Solitax actual value and rake value
First prepare two black buckets, and separately load water samples with different TS values ​​(the TS value of the two buckets of water should preferably represent the value of the online measured water sample, and the difference should not be too small), and the two buckets of water samples were measured by the laboratory method. The TS value (this is the target value, which will be mentioned later), and then the cleaned lower part of the Solitax probe is immersed in the first bucket of water sample (note that the probe needs to maintain a certain distance from the bucket wall), the controller press Menu → sensor settings → Calibration → Sensor measurement value, record this value as the actual value of the first point. Measure the actual value of the second point in the same way and write it down. At this point we have two sets of data: the target value and actual value of the first point, and the target value and actual value of the second point. Next, go back to the “Calibration†menu of the controller, select 2 points → first point → target value → enter the target value of the first point (left and right keys to change position, up and down keys to adjust the number, press enter after completing the input) → press back Key → actual value → input the actual value of the first point. Since then, the first point of data entry has been completed. Then return to the "Calibration" menu, select 2 points → second point → target value → enter the target value of the second point → press the back key → actual value → enter the actual value of the second point and press Enter. Since the two-point calibration is completed, the instrument should be able to be used normally.
For more details, please click
Kids Bucket Hats,Frog Fisherman Hat,Summer Outdoor Sun Protection Cap,Women's Bucket Hats
Hun Yuan Ya Lian Wan Jia Dian Zi Shang Wu You Xian Ze Ren Gong Si , https://www.ylwjastragalus.com